Service | Concept2

PM3 Troubleshooting

Cannot Update Firmware with the USB Cable and Concept2 Utility

If you have tried to update the firmware in your PM more than once and are encountering problems, follow the procedure below to reset the PM.

This topic applies to all PM3s, PM4s and PM5s when updating firmware using the Concept2 Utility and a USB cable.

On the PM5, press the first and 5th buttons down the right hand side, and the left-most button on the bottom

  1. Simultaneously press and hold the Change Units button, as well as the first and fifth grey buttons on the right (see image).
  2. While holding these buttons, reset the monitor using a paper clip and the reset button on the back of the monitor.
  3. Release the buttons when the PM displays "Concept2 Flash Loader.”
  4. If the issue is not resolved, close and restart the Concept2 Utility. If the issue persists, try rebooting your computer and attempting the update again.

If you have performed the reset and are still encountering problems with the update, please note the PM screen contents (error messages, etc.) and contact Concept2 for assistance (c2@jnbsports.com or +91 9764144222).

Note for MacBook Users: If you have attempted the update multiple times without success, try another USB port. Some MacBook users have reported that this resolved the issue. If the problem persists, contact Concept2 for assistance.

For additional firmware update troubleshooting, see Concept2 Utility Troubleshooting.

Encountering Errors

If you encounter an error during the firmware update, recover the PM by taking the following steps and trying again:

  • Remove all other USB devices (printers, scanners, hubs, and so on) while updating your PM.
  • Try connecting your PM to a different USB port. Concept2 recommends plugging in directly to a USB port on your computer and not using a hub.
  • Try the update on another computer.

If you encounter a problem, we would like to hear from you. Please email c2@jnbsports.com or contact Concept2 at +91 9764144222.